Zinc-plated T-nuts M 10
You use T-nuts for the fastening of climbing holds on a wooden wall. T-nuts are the counter pieces of hexagon socket screws.
The quality of our T-nuts
Please notice that we only offer high-quality T-nuts weighing 8 g. Many other suppliers offer T-nuts weighing just 6,7 g. These T-nuts can easily turn off. Thus, pay attention to price-quality ratio!
- Internal screw thread M 10
- Cylinder head screw DIN EN ISO 4762 - M10 (DIN 912)
- Countersunk head screw DIN EN ISO 10642 - M10 (DIN 7991 )
First you have to make a raster. Therefore, mark all places where you want to assemble T-nuts. For boulder walls, a hole matrix of 10 cm is advisable (demand/qm: 95 T-nuts). The first row should be displaced to the second row.
You can also use only as many T-Nuts as climbing holds. Then you have only few opportunities to assemble your climbing holds. Furthermore, if you want to expand your climbing wall you`ll have to demount all plates.
After marking all places for your T-nuts, you have to bore 12 mm holes. Then, T-nuts must be installed in the back of your climbing wall. Use a special wood adhesive to give T-nuts a better hold.
If adhesive gets into contact with screw thread you´ll have to clean your T-nut afterward.